# Options related to paths and install

comment "Paths"

config LOCAL_TARBALLS_DIR

    string

    prompt "Local tarballs directory" if ! BACKEND

    default ""

    help

      If you have previously downloaded the tarballs, enter the PATH where

      you stored them here.

config SAVE_TARBALLS

    bool

    prompt "Save new tarballs" if ! BACKEND

    depends on LOCAL_TARBALLS_DIR != "" || BACKEND

    default y if BACKEND

    default n if ! BACKEND

    help

      If you say 'y' here, new downloaded tarballs will be saved in the

      directory you entered above.

config WORK_DIR

    string

    prompt "Working directory" if ! BACKEND

    default "${CT_TOP_DIR}/targets"

    help

      Set this to the directory where all build actions will be done.

      The default is "${CT_TOP_DIR}/targets", and leaving this option

      empty will also use the default.

      You should not need to change that, except in one very peculiar

      setup:

       - your crosstool-NG source directory is on the network

       - you configured crosstool-NG with --local

      This kind of setup is a pain, as any action involving source file

      access would have to go through the wire. In this case, you should

      set CT_WORK_DIR to point to a path local to your machine, to avoid

      any network overhead.

      Do *NOT* change it if you don't know better.

config PREFIX_DIR

    string

    prompt "Prefix directory" if ! BACKEND

    default "${HOME}/x-tools/${CT_TARGET}"

    help

      This is the path the toolchain will run from.

config INSTALL_DIR

    string

#    prompt "Install directory"

    default "${CT_PREFIX_DIR}"

#    help

#      This is the path the toolchain will be installed into.

#      

#      Normally, you would set this to ${CT_PREFIX_DIR}, but if for some reasons

#      you can't write there, you can install somewhere else and have a third

#      person do the install for you.

#      The reason you might also want to install elsewhere is if you are going

#      to package your shinny new toolchain for distribution.

config REMOVE_DOCS

    bool

    prompt "Remove documentation"

    default y

    help

      Remove the installed documentation (man and info pages).

      Gains around 8MiB for a uClibc-based, C and C++ compiler.

config INSTALL_DIR_RO

    bool

    prompt "Render the toolchain read-only"

    default y

    help

      Render the directory of the toolchain (and its sub-directories)

      read-only.

      Usefull for toolchains destined for production.

config STRIP_ALL_TOOLCHAIN_EXECUTABLES

    bool

    prompt "Strip all toolchain executables"

    default y

    help

      All build host executables contain a lot of unnecessary info.

      By stripping all executables it slightly speeds up the compilation

      of large projects.

      NOTE: It does NOT strip the target libraries, only HOST executables