| author | Remy Bohmer <linux@bohmer.net> |
| Thu May 27 23:18:19 2010 +0200 (2010-05-27) | |
| changeset 2060 | 51e4597b07fc |
| permissions | -rw-r--r-- |
| titus@1988 | 1 |
22 May 2010 - Titus von Boxberg |
| titus@1988 | 2 |
|
| titus@1988 | 3 |
Prerequisites and instructions for using ct-ng for building a cross toolchain on FreeBSD as host. |
| titus@1988 | 4 |
|
| titus@1988 | 5 |
0) Tested on FreeBSD 8.0 |
| titus@1988 | 6 |
|
| titus@1988 | 7 |
1) Install (at least) the following ports |
| titus@1988 | 8 |
archivers/lzma |
| titus@1988 | 9 |
textproc/gsed |
| titus@1988 | 10 |
devel/gmake |
| titus@1988 | 11 |
devel/patch |
| titus@1988 | 12 |
shells/bash |
| titus@1988 | 13 |
devel/bison |
| titus@1988 | 14 |
lang/gawk |
| titus@1988 | 15 |
devel/automake110 |
| titus@1988 | 16 |
ftp/wget |
| titus@1988 | 17 |
|
| titus@1988 | 18 |
Of course, you should have /usr/local/bin in your PATH. |
| titus@1988 | 19 |
|
| titus@1988 | 20 |
2) run ct-ng's configure with the following tool configuration: |
| titus@1988 | 21 |
./configure --with-sed=/usr/local/bin/gsed --with-make=/usr/local/bin/gmake \ |
| titus@1988 | 22 |
--with-patch=/usr/local/bin/gpatch |
| titus@1988 | 23 |
[...other configure parameters as you like...] |
| titus@1988 | 24 |
|
| titus@1988 | 25 |
3) proceed as described in general documentation |
| titus@1988 | 26 |
but use gmake instead of make |