Sample config for e500v2 toolchain

On Tuesday 14 October 2008 17:05:31 Nate Case wrote:
> This is a sample config file for Freescale e500v2 processors (e.g.,
> MPC8548, MPC8572). It uses eglibc (for e500/SPE patches) and a recent
> gcc (4.3.1, for e500v2 DPFP support) and will generate appropriate
> dual-precision floating point instructions by default.
>
> Note: If building a Linux kernel with this toolchain, you will want to
> make sure -mno-spe AND -mspe=no are passed to gcc to prevent SPE
> ABI/instructions from getting into the kernel (which is currently
> unsupported). At this time, the kernel build system only passes
> -mno-spe by default (this should be fixed soon hopefully).
>
> A binutils snapshot is used to fix a bug present in 2.18 preventing
> U-Boot from being compiled (CodeSourcery issue #2297: internal.h
> (ELF_IS_SECTION_IN_SEGMENT): Adjust to cope with segments at the end of
> memory).

Obsoletes the powerpc-unknown-linux-gnuspe sample, so remove it.

/trunk/samples/powerpc-e500v2-linux-gnuspe/crosstool.config | 307 307 0 0 +++++++++++++++++++
1 file changed, 307 insertions(+)

# Super-H specific configuration file

# EXPERIMENTAL

config ARCH_sh

    select ARCH_SUPPORTS_BOTH_ENDIAN

    select ARCH_DEFAULT_LE

    help

      The Super-H architecture, as defined by:

        http://www.renesas.com/fmwk.jsp?cnt=superh_family_landing.jsp&fp=/products/mpumcu/superh_family/

choice

    bool

    prompt "Variant"

config ARCH_SH_SH3

    bool

    prompt "sh3"

config ARCH_SH_SH4

    bool

    prompt "sh4"

config ARCH_SH_SH4A

    bool

    prompt "sh4a"

endchoice

config ARCH_SH_VARIANT

    string

    default "sh3"   if ARCH_SH_SH3

    default "sh4"   if ARCH_SH_SH4

    default "sh4a"  if ARCH_SH_SH4A