1 # Options related to paths and install
5 config LOCAL_TARBALLS_DIR
7 prompt "Local tarballs directory" if ! BACKEND
10 If you have previously downloaded the tarballs, enter the PATH where
15 prompt "Save new tarballs" if ! BACKEND
16 depends on LOCAL_TARBALLS_DIR != "" || BACKEND
19 If you say 'y' here, new downloaded tarballs will be saved in the
20 directory you entered above.
24 prompt "Working directory" if ! BACKEND
25 default "${CT_TOP_DIR}/.build"
27 Set this to the directory where all build actions will be done.
29 The default is "${CT_TOP_DIR}/.build", and leaving this option
30 empty will also use the default.
32 You should not need to change that, except in one very peculiar
34 - your crosstool-NG source directory is on the network
35 - you configured crosstool-NG with --local
36 This kind of setup is a pain, as any action involving source file
37 access would have to go through the wire. In this case, you should
38 set CT_WORK_DIR to point to a path local to your machine, to avoid
41 Do *NOT* change it if you don't know better.
45 prompt "Prefix directory" if ! BACKEND
46 default "${HOME}/x-tools/${CT_TARGET}"
48 This is the path the toolchain will run from.
52 # prompt "Install directory"
53 default "${CT_PREFIX_DIR}"
55 # This is the path the toolchain will be installed into.
57 # Normally, you would set this to ${CT_PREFIX_DIR}, but if for some reasons
58 # you can't write there, you can install somewhere else and have a third
59 # person do the install for you.
60 # The reason you might also want to install elsewhere is if you are going
61 # to package your shinny new toolchain for distribution.
63 config RM_RF_PREFIX_DIR
65 prompt "| Remove the prefix dir prior to building"
69 If you say 'y' here, then PREFIX_DIR (above) will be eradicated
70 prior to the toolchain is built.
72 This can be useful when you are trying different settings (due
73 to build failures or feature tests). In this case, to avoid using
74 a potentially broken previous toolchain, the install location is
75 removed, to start afresh.
77 On the other hand, if you are building a final toolchain, and install
78 it into a directory with pre-install, unrelated programs, it would be
79 damageable to remove that directory. In this case, you may want to
82 Note that when acting as a backend, this option is not available, and
87 prompt "Remove documentation"
90 Remove the installed documentation (man and info pages).
91 Gains around 8MiB for a uClibc-based, C and C++ compiler.
95 prompt "Build the manuals"
96 depends on ! REMOVE_DOCS
98 Build the PDF and HTML manuals for the main components such as
99 binutils, GCC, GDB, and the C library.
101 config INSTALL_DIR_RO
103 prompt "Render the toolchain read-only"
106 Render the directory of the toolchain (and its sub-directories)
109 Useful for toolchains destined for production.
111 config STRIP_ALL_TOOLCHAIN_EXECUTABLES
113 prompt "Strip all toolchain executables"
116 All build host executables contain a lot of unnecessary info.
117 By stripping all executables it slightly speeds up the compilation
119 NOTE: It does NOT strip the target libraries, only HOST executables